Tags

Power management fix for v4.15-rc4

This fixes an issue in two recent commits that may cause
pm_runtime_enable() to be called for too many times for some
devices during the "thaw" transition belonging to hibernation.

- Fix documentation build issues (Randy, Markus)
- Fix timestamp frequency calculation for perf on CNL (Lionel)
- New DMC firmware for Skylake (Anusha)
- GTT flush fixes and other GGTT write track and refactors (Chris)
- Taint kernel when GPU reset fails (Chris)
- Display workarounds organization (Lucas)
- GuC and HuC initialization clean-up and fixes (Michal)
- Other fixes around GuC submission (Michal)
- Execlist clean-ups like caching ELSP reg offset and improving log readability (Chri\
s)
- Many other improvements on our logs and dumps (Chris)
- Restore GT performance in headless mode with DMC loaded (Tvrtko)
- Stop updating legacy fb parameters since FBC is not using anymore (Daniel)
- More selftest improvements (Chris)
- Preemption fixes and improvements (Chris)
- x86/early-quirks improvements for Intel graphics stolen memory. (Joonas, Matthew)
- Other improvements on Stolen Memory code to be resource centric. (Matthew)
- Improvements and fixes on fence allocation/release (Chris).

GVT:

- fixes for two coverity scan errors (Colin)
- mmio switch code refine (Changbin)
- more virtual display dmabuf fixes (Tina/Gustavo)
- misc cleanups (Pei)
- VFIO mdev display dmabuf interface and gvt support (Tina)
- VFIO mdev opregion support/fixes (Tina/Xiong/Chris)
- workload scheduling optimization (Changbin)
- preemption fix and temporal workaround (Zhenyu)
- and misc fixes after refactor (Chris)

drm/i915 fixes for v4.15-rc4

drm-misc-next for 4.16:

Cross-subsystem Changes:

 - Documentation for amlogic dt dt-bindings

Core Changes:

 - Update edid-derived drm_display_info fields at edid property set

Driver Changes:

 - A bunch of clean up from Noralf, including the last patches to reduce
 fbdev emulation footprint.

drm-misc-fixes for 4.15-rc4

This is the 4.14.6 stable release

This is the 4.9.69 stable release

Linux 4.1.48

Three fixes:
 * for certificate C file generation, don't use hexdump as it's
   not always installed by default, use pure posix instead (od/sed)
 * for certificate C file generation, don't write the file if
   anything fails, so the build abort will not cause a bad build
   upon a second attempt
 * fix locking in ieee80211_sta_tear_down_BA_sessions() which had
   been causing lots of locking warnings

Linux 4.15-rc3

This is the 4.14.5 stable release

This is the 4.9.68 stable release

This is the 4.4.105 stable release

This is the 3.18.87 stable release

media fixes for v4.15-rc3

DeviceTree fixes for v4.15 (part2):

- Fixes from overlay code rework. A trifecta of fixes to the locking,
  an out of bounds access, and a memory leak in of_overlay_apply().

- Clean-up at25 eeprom binding document

- Remove leading '0x' in unit-addresses from binding docs

wireless-drivers fixes for 4.15

Second set of fixes for 4.15. This time a lot of iwlwifi patches and
two brcmfmac patches. Most important here are the MIC and IVC fixes
for iwlwifi to unbreak 9000 series.

iwlwifi

* fix rate-scaling to not start lowest possible rate

* fix the TX queue hang detection for AP/GO modes

* fix the TX queue hang timeout in monitor interfaces

* fix packet injection

* remove a wrong error message when dumping PCI registers

* fix race condition with RF-kill

* tell mac80211 when the MIC has been stripped (9000 series)

* tell mac80211 when the IVC has been stripped (9000 series)

* add 2 new PCI IDs, one for 9000 and one for 22000

* fix a queue hang due during a P2P Remain-on-Channel operation

brcmfmac

* fix a race which sometimes caused a crash during sdio unbind

* fix a kernel-doc related build error

i915, amdgpu + misc fixes

ACPI fix for v4.15-rc3

This fixes an out of bounds warning from KASAN in the ACPI
CPPC driver.

Power management fix for v4.15-rc3

This fixes an issue in the device runtime PM framework that prevents
customer devices from resuming if runtime PM is disabled for one or
more of their supplier devices (as reflected by device links between
those devices).